GSW: Waterslide Decal Sheets – Train and Graffiti Mix (Black)
This set includes 2 sheets of full colour opaque high-detailed waterslide decals. Decals are to be applied with water, no solvent required. You can also use some Decal Softener and Decal Fixer solutions to improve and protect the finish on uneven or rough surfaces.
Each waterslide decal sheet contains a huge variety of graffiti of different sizes and shapes which will allow you to customize your battlefield, building and diorama.
Approximate Scale: 28–32–54mm (1/58–1/54–1/32)
Sheets: 2 per package
Size: 148 × 210mm (A5)
BASIC INSTRUCTIONS
1.- Cut the decal out as close as you can to the outer edge of the image. For
better results, use a brand new blade in your cutter.
2.- Pick the decal up with your tweezers and let your decal soak in water for
about 20 seconds. Warm water may help with this process.
3.- Use a paintbrush to gently push the decal off the sheet and onto the model.
That's all folks!
ADVANCED INSTRUCTIONS
4.- Before applying it to the model, once the decal has soaked long enough,
apply a bit of Decal Fixer to the surface of the model where you are planning to
set your decal. Decal Fixer protects the paint beneath and smooths the surface,
thereby helping to prevent silvering. Use a paintbrush to gently push the decal
off the sheet and onto the model. If it is hard to move the decal around, adding
bit more Decal Fixer or water will help the decal float on the surface until it
is positioned correctly.
5.- If the surface where you want to apply the flat decal is curved, like a
shoulder pad, your decal could become wrinkled. To avoid this, once your decal
is in place, apply Decal Softener. Let the softener react and it will help
remove wrinkles, as it adapts to the curved surface underneath. Repeat this step
2–3 times till wrinkles are removed.
Remove any excess with a cotton swab to remove the liquid caught between the
decal and the surface. Roll the swab over the decal so it does not lift from the
surface. You can also use a paper towel to press down on the decal in a rolling
motion to remove the excess of liquids. By using Decal Softener the relief cuts
to remove wrinkles in your decal will not be needed.
6.- Finally apply Decal Fixer again to the decal and the surface of the model
where we have been working to unify the surface. Coat it as normal with matt or
gloss varnish if you consider it necessary to remove or add a glossy finish.